蔡耀辉,吴普特,张林,朱德兰,任改萍,陈俊英.微孔陶瓷渗灌与地下滴灌土壤水分运移特性对比[J].农业机械学报,2017,48(4):242-249.
CAI Yaohui,WU Pute,ZHANG Lin,ZHU Delan,REN Gaiping,CHEN Junying.Comparison of Characteristics of Soil Moisture Transfer for Porous Ceramic Infiltration Irrigation and Subsurface Drip Irrigation[J].Transactions of the Chinese Society for Agricultural Machinery,2017,48(4):242-249.
摘要点击次数: 2143
全文下载次数: 1418
微孔陶瓷渗灌与地下滴灌土壤水分运移特性对比   [下载全文]
Comparison of Characteristics of Soil Moisture Transfer for Porous Ceramic Infiltration Irrigation and Subsurface Drip Irrigation   [Download Pdf][in English]
投稿时间:2016-08-05  
DOI:10.6041/j.issn.1000-1298.2017.04.031
中文关键词:  微孔陶瓷  渗灌  地下滴灌  土壤水分运移  土壤含水率
基金项目:“十二五”国家科技支撑计划项目(2015BAD22B01-02)、国家自然科学基金项目(51409221)、西北农林科技大学基本科研业务费专项资金项目(2014YB061)和石河子大学高层次人才科研启动资金专项(RCZX201434)
作者单位
蔡耀辉 西北农林科技大学 
吴普特 西北农林科技大学 
张林 西北农林科技大学 
朱德兰 西北农林科技大学 
任改萍 西北农林科技大学
洛南县水务局 
陈俊英 西北农林科技大学 
中文摘要:以微孔陶瓷灌水器为研究对象,在0m工作水头下进行土壤水分运移特性试验,并以10m额定工作水头下工作的地下滴灌灌水器作为对照。通过对比分析2种灌溉方式下累计入渗量、流量、湿润体特征和土壤含水率变化,结果表明:相同灌溉时间下微孔陶瓷渗灌的累计入渗量、湿润锋运移距离、湿润体截面面积均明显小于地下滴灌。微孔陶瓷渗灌的流量随时间逐渐减小,直至接近于零;试验后期,微孔陶瓷渗灌湿润体内整体土壤含水率变化较小;由于微孔陶瓷渗灌为无压连续灌溉,因此在其工作过程中可为作物提供一个恒定的水分环境。而地下滴灌的流量则会维持稳定,使得土壤含水率一直增大,停止灌溉后由于土壤水分再分布而减小。地下滴灌为被动恒压灌溉,因此其灌溉条件下作物生长的水分环境处于干湿交替的循环变化状态。
CAI Yaohui  WU Pute  ZHANG Lin  ZHU Delan  REN Gaiping  CHEN Junying
Northwest A&F University,Northwest A&F University,Northwest A&F University,Northwest A&F University,Northwest A&F University;Luonan Water Affairs Bureau and Northwest A&F University
Key Words:porous ceramic  infiltration irrigation  subsurface drip irrigation  soil moisture transfer  soil water content
Abstract:Aiming to have insights into characteristics of soil moisture transfer of porous ceramic infiltration irrigation, soil moisture transfer experiment was conducted by using porous ceramic emitter, of which the working head was 0m, meanwhile, subsurface drip irrigation tape with working head of 10m was used to carry out a control test. The comparisons of cumulative infiltration, emitter discharge, wetting soil characteristic and change of soil water content of two different irrigation methods were made. The results indicated that when the irrigation time was the same, the cumulative infiltration, wetting front and wetting zone sectional area of porous ceramic infiltration irrigation were less than those of subsurface drip irrigation. The discharge of porous ceramic infiltration irrigation was decreased gradually with the increase of time, which was closed to 0L/h at last, in contrast, the discharge of subsurface drip irrigation was relatively stable. In the late experimental period, soil water contents in the wetting zone of porous ceramic infiltration irrigation were changed slightly. While water contents of subsurface irrigation were increased continuously, and then they got decreased after stopping irrigation because of soil water redistribution. Because porous ceramic infiltration irrigation was a continuous irrigation method, thus it could provide a constant soil moisture environment for crops. But subsurface drip irrigation was a passive and intermittent irrigation method, and soil moisture environment for crops was alternate drying-wetting. The present study provided valuable information for the popularization and application of porous ceramic infiltration irrigation.

Transactions of the Chinese Society for Agriculture Machinery (CSAM), in charged of China Association for Science and Technology (CAST), sponsored by CSAM and Chinese Academy of Agricultural Mechanization Science(CAAMS), started publication in 1957. It is the earliest interdisciplinary journal in Chinese which combines agricultural and engineering. It always closely grasps the development direction of agriculture engineering disciplines and the published papers represent the highest academic level of agriculture engineering in China. Currently, nearly 8,000 papers have been already published. There are around 3,000 papers contributed to the journal each year, but only around 600 of them will be accepted. Transactions of CSAM focuses on a wide range of agricultural machinery, irrigation, electronics, robotics, agro-products engineering, biological energy, agricultural structures and environment and more. Subjects in Transactions of the CSAM have been embodied by many internationally well-known index systems, such as: EI Compendex, CA, CSA, etc.

   下载PDF阅读器