Inner gear spinning technology with three rollers was analyzed. According to the material flowing characteristics during spin-forming, two forming quality evaluation factors were put forward and then filling status of gear tooth under different reductions was analyzed. The results indicated that there was an optimum reduction for blank with certain thickness during inner gear spinning. When the reduction was below, the filling status in gear tooth was unsatisfied due to lack of filling material; when the radial reduction was above, the increasing forming force induced by higher reduction would likely decrease the service life of forming tool, and excess relative reduction would result in the status of underfills in the gear tooth.
参考文献
相似文献
引证文献
引用本文
孙凌燕,夏琴香,叶邦彦,程秀全.压下量对梯形内齿轮旋压成形质量的影响[J].农业机械学报,2010,41(8):206-210. Reduction on Quality of Trapezoidal Inner Gear Formed by Spinning[J]. Transactions of the Chinese Society for Agricultural Machinery,2010,41(8):206-210.